IATF 16949 Quality Management Software

IATF 16949: 2016 is the most important of the quality certificates that companies in the automotive supply chain should take.
The International Automotive Task Force (IATF) published a revised quality management system (QMS) standard specifically for the automotive industry, as known as IATF 16949:2016.

FMEA, IPC, SPC, MSA, Proficiency Analyzes, APQP / PPAP, Change Management, Product data management.

Failure Mode and Effects Analysis (FMA)

The FMEA method usually focuses on the analysis of parts and equipment.
This method solves each of the places and areas where failure can ocur.

Application of Error Mode and Impact Analysis;

Identify the causes and causes of each mistake,
Identify potential errors,
Depending on the probability, severity and detectability, it reveals the priority of errors,
It ensures that problems are monitored and corrective actions are taken.

Statistical Process Control (SPC)

SPC (IPK) studies focus more on the process than the operator as a source of quality problems.
In particular, it investigates the identification and resolution of defects and problems in production methods, raw materials, working environment and materials, even though they are also concerned with factors such as bad operators that do not form the basis of quality problems.

Process / Process Capability Analysis

This concept is one of the basic concepts of statistical process control topics and is a factor that helps us to have information about the general process of the process.
The process capability analyzes carried out in order to demonstrate process production capability are expressed numerically as Cp and Cpk indices.

Measurement Systems Analysis (MSA)

The IATF 16949 Quality Management System wishes to ensure that all the data are measured correctly, especially in the customer's special wishes, during each new product launch and serial manufacturing phase. The MSA module is designed for this purpose.

What Does the Measurement System Contain?

Measuring devices,
The measuring operators,
The measurement environment,
Measurement procedures and
Includes auxiliary equipment for measurement.

Production Part Approval Process (APQP – PPAP)

During the process of commissioning a new product, preparations required by the IATF 16949 quality management system and the preparation of a number of documents under the APQP / PPAP heading are required.

APQP / PPAP module;

From the very beginning of the process,
Assigning responsibility to all relevant teams,
To be reminded of the works to be done in the process and to inform the concerned persons,
Documents are prepared in time and controlled progressive,
Provides the ability to record and access parts documents in a specific hierarchy.